Rear Brake Pedal Position Adjustment; Rear Brake Pedal Free Play Adjustment - Husqvarna WRE 125 2011 Workshop Manual

1
2
5
4
Ed. 05-2011
SETTINGS AND ADJUSTMENTS

Rear brake pedal position adjustment

The position of the rear brake pedal with respect to the footrest may be adjusted
according to individual needs.
For adjusting, proceed as follows:
- Loosen the screw (1).
- Turn the cam (2) in order to raise or lower the brake pedal (3) within the range
available (A).
- When finished, tighten the screw (1).
Once this adjustment is completed, adjust the free play of the pedal following the
instructions provided in paragraph "Rear brake pedal free play adjustment".
H02647
A
3
H02648

Rear brake pedal free play adjustment

The rear brake pedal (3) should have 5 mm free play (B) before the brake begins
to bite. Should this not happen, operate as follows:
- Loosen the nut (4);
B - Operate the master cylinder linkage (5) to increase or decrease free play;
- Tighten the nut (4) at the end of the operation.
3
H02649
H02650
When the free play requirement is not met, the brake pads will be
subjected to an early wear that may lead to TOTAL BRAKE INEF-
FECTIVENESS.
If the brake pedal feels mushy when pulled, there may be air in the
brake line or the brake may be defective. CHECK THE BRAKING
SYSTEM (see Section L).
D.11