Rear Chassis Complete With Mudguard And Air Boxremoval - Husqvarna CR 50 / 2011 Workshop Manual

1
3
4
5
2
GENERAL PROCEDURES
Rear chassis complete with mudguard and air box removal
- Remove the saddle as described in the relevant paragraph.
2
- Remove the side panels as described in the relevant paragraph.
- Remove the fuel tank as described in section "D".
- Remove the exhaust silencer as described in the relevant paragraph.
- Slacken the clamp (1) that secures the rubber coupling (2) of the air box at
the carburettor end (3).
H02082
- Work with a 6 mm Allen wrench on the left side and a 12 mm ring wrench on
the right side. Remove nut (4), leaving pin in its position.
H02084
- Remove the lower fixing (5) on both sides of the rear chassis using a 10 mm
ring wrench.
H02085
- Lift the subframe (6) at the rear end so as to release carburettor rubber union
(2).
6
H02086
E.6 Ed. 01-09-2010