Husqvarna WRE 125 2011 Workshop Manual page 132

4
D
H06659
H06606
H06607
ENGINE ASSEMBLY
Fit the original shim (4) on starter shaft end, and insert it in the right crankcase
half seat. Mind the positioning of the clutch spring end, it must be fitted between
the rear end of the crankcase half and the protruding tooth (D).
Pre-charge the lever return spring by turning its end clockwise until it is fitted
inside the special crankcase half hole.
1
Fit the selector shaft with spacer spring inside the crankcase half. Position it
so that the pin on the crankcase half can be inserted between the ends of the
selector shaft spring and that the two pins of the selector shaft are between the
selector teeth.
1
H.8 Ed. 05-2011