Assembling The Propeller Shaft Housing - Yamaha F200C Service Manual

LOWR
2. Check the dog clutch, shift rod joint, and
shift slider for cracks or wear. Replace if
necessary.
Assembling the propeller shaft
housing
1. Install the needle bearing into the propel-
ler shaft housing to the specified depth.
È
NOTE:
Install the needle bearing with the manufac-
ture identification mark a facing toward the
oil seal (propeller side).
Driver handle 1: YB-06071
Drive shaft needle bearing remover
and installer 2:
YB-06196
Depth b:
25.05–25.55 mm (0.986–1.006 in)
2. Apply grease to the new oil seals, and
then install them into the propeller shaft
housing to the specified depth.
6-39
Lower unit
È
NOTE:
Install an oil seal halfway into the propeller
shaft housing, then the other oil seal.
Oil seal installer 3: YB-06195
Driver handle 4: YB-06071
Depth c:
4.75–5.25 mm (0.187–0.207 in)
3. Install the original shim(s) 5 and thrust
bearing 6 with the propeller shaft into
the propeller shaft housing.
CAUTION:
Add or remove shim(s), if necessary,
when replacing the propeller shaft, thrust
bearing or propeller shaft housing.
4. Install the new taper roller bearing 7 and
bearing outer race 8 into the propeller
shaft housing using a press.
S69J6425
69J1D11