Disassembling The Tilt Cylinder And Trim Cylinders - Yamaha F200C Service Manual

3. Remove the bracket 5, then the balls 6.
4. Remove the gear housing 2 7, then the
shuttle pistons 8.
5. Remove the drive gear 9, balls 0, and
dowel pins A.
69J1D11
Power trim and tilt unit
Disassembling the tilt cylinder and
trim cylinders
1. Hold the tilt cylinder 1 in a vise using
aluminum plates a on both sides.
2. Loosen the tilt cylinder end screw 2, and
then remove the tilt piston assembly.
WARNING
Make sure that the rams are fully
extended before removing the end screw.
Trim and tilt cylinder wrench:
YB-06175-2B
3. Drain the power trim and tilt fluid.
4. Remove the free piston 3, and then
blow compressed air through the hole b
while holding down the cloth.
1
2
3
4
5
6
7
8
9
7-32