Good Working Practices; Disassembly And Assembly; Identification; Applicable Models - Yamaha F200C Service Manual

6. Keep a supply of clean, lint-free cloths for
wiping up spills, etc.

Good working practices

Special tools
Use the recommended special tools to pro-
tect parts from damage. Use the right tool in
the right manner—do not improvise.
Tightening torques
Follow the tightening torque specifications
provided throughout the manual. When tight-
ening nuts, bolts, and screws, tighten the
large sizes first, and tighten fasteners starting
in the center and moving outward.
Non-reusable parts
Always use new gaskets, seals, O-rings, cot-
ter pins, circlips, etc., when installing or
assembling parts.

Disassembly and assembly

1. Use compressed air to remove dust and
dirt during disassembly.
2. Apply engine oil to the contact surfaces
of moving parts before assembly.
69J1D11
Safety while working / Identification
3. Install bearings with the manufacture
identification mark in the direction indi-
cated in the installation procedure. In
addition, be sure to lubricate the bearings
liberally.
4. Apply a thin coat of water-resistant
grease to the lip and periphery of an oil
seal before installation.
5. Check that moving parts operate nor-
mally after assembly.

Identification

Applicable models

This manual covers the following models.
Applicable models
F200TR, LF200TR, F225TR, LF225TR

Serial number

The outboard motor
stamped on a label attached to the port
clamp bracket.
1
serial number is
1-4
1
2
3
4
5
6
7
8
9