Assembling The Propeller Shaft Assembly; Assembling The Propeller Shaft Housing - Yamaha F150A Service Manual

Assembling the propeller shaft
assembly
1. Install the dog clutch as shown.
NOTE:
Install the dog clutch 1 with the "F" mark a
facing toward the shift slider.
Assembling the propeller shaft
housing
1. Install the needle bearing into the propel-
ler shaft housing to the specified depth.
63P3F11
Propeller shaft housing (regular rotation model)
NOTE:
• Install the needle bearing with the manufac-
ture identification mark a facing toward the
oil seal (propeller side).
• When using the driver rod, do not strike the
special service tool in a manner that will
force the stopper c out of place.
Driver rod SS 1: 90890-06604
Needle bearing attachment 2:
90890-06610
Bearing depth plate 3: 90890-06603
Depth b:
24.75–25.25 mm (0.974–0.994 in)
2. Apply grease to new oil seals, and then
install them into the propeller shaft hous-
ing to the specified depth.
NOTE:
Install an oil seal halfway into the propeller
shaft housing, then the other oil seal.
Bearing inner race attachment 4:
90890-06640
Depth d:
4.75–5.25 mm (0.187–0.207 in)
1
2
3
4
5
6
7
8
9
6-14