Yamaha F200C Service Manual page 121

5. Disconnect the stator coil couplers 3
and pulser coil coupler 4, and remove
the blowby hose 5 and stator coil
bracket 6.
6. Remove the wiring harness guide bolts.
NOTE:
Move the wiring harness guide 7 to a posi-
tion that will make servicing easy.
7. Using a hexagon wrench, turn the timing
belt tensioner 8 clockwise to push the
timing belt, increase strength gradually,
and then insert a ø5.0 mm (0.2 in) pin 9
into the hole g.
NOTE:
Leave the pin inserted into the timing belt
tensioner until the timing belt has been
installed.
8. Remove the timing belt 0 from the
driven sprocket side.
69J1D11
9. Check that "I" marks c and d on the
driven sprockets are aligned with marks
e and f, and that the " " mark h on
the plate is aligned with the " " mark i
on the cylinder block. Align if necessary.
10. Install the timing belt A from the drive
sprocket side with its part number in the
upright position, turn the belt a half turn
counterclockwise to align it, and then
remove the pin 9.
Power unit
1
2
3
4
5
6
7
8
9
5-22