Installing The Lower Unit - Yamaha F200C Service Manual

7. Install the O-ring D and pump housing
assembly E into the lower case, tighten
the bolts F, and then install the seal G
and cover H.
LT
572
NOTE:
• When installing the pump housing, apply
grease to the inside of the housing, and
then turn the drive shaft clockwise while
pushing down the pump housing.
• Align the cover projection d with the hole
e in the pump housing.

Installing the lower unit

1. Set the gearshift to the neutral position at
the lower unit.
69J1D11
Drive shaft and lower case (regular rotation model)
A A
S69J6315
È
Shift rod push arm: YB-06052
2. Install the two dowel pins 1 to the lower
unit.
3. Install the lower unit to the upper case,
and then tighten the bolts 2 to the speci-
fied torque.
4. Install the trim tab 3 to its original posi-
tion, and then tighten the bolt 4 to the
specified torque.
Lower case bolts 2:
47 N·m (4.7 kgf·m, 34 ft·lb)
Trim tab bolt 4:
43 N·m (4.3 kgf·m, 31 ft·lb)
1
2
3
4
5
6
7
8
9
6-22