Assembling The Trim Rams - Yamaha F200C Service Manual

BRKT
2. Install the tilt cylinder end screw 6,
spring 7, adapter 8, and tilt piston 9 to
the tilt ram 5.
3. Hold the tilt piston in a vise using the
special service tool A on both sides.
4. Tighten the tilt ram 0 to the specified
torque.
PTT piston vice attachment A:
YB-06572
Tilt rod wrench B: YB-06569
7-37
Bracket unit
Tilt ram 0:
55 N·m (5.5 kgf·m, 40 ft·lb)
5. Install the new O-ring C and backup ring
D into the tilt piston 9.
6. Install the balls E, absorber valve pins
F, and springs G as shown.
7. Install the washers H, plate I, and bolt
J to the tilt piston 9, and then tighten
the bolt to the specified torque.
Tilt piston bolt J:
7 N·m (0.7 kgf·m, 5.1 ft·lb)

Assembling the trim rams

1. Install the trim piston 1 to the trim ram
2.
2. Hold the trim ram 2 in a vise using alu-
minum plates a on both sides.
3. Tighten the trim piston bolt to the speci-
fied torque.
69J1D11