Replacing The Oil Filter - Yamaha F200C Service Manual

CHK
ADJ
NOTE:
Be sure to clean up any oil spills.
5. Install the drain bolt, and then tighten it to
the specified torque.
Drain bolt:
27 N·m (2.7 kgf·m, 19 ft·lb)
6. Pour the specified amount of the recom-
mended engine oil into the oil filler hole.
Recommended engine oil:
4-stroke motor oil
API: SE, SF, SG, SH, or SJ
SAE: 10W-30 or 10W-40
Oil quantity:
Without oil filter replacement:
5.8 L (6.1 US qt, 5.1 Imp qt)
7. Install the oil filler cap and dipstick, and
then start the engine and warm it up for 5
minutes.
8. Turn the engine off, and then check the
oil level and correct it if necessary.
9. Install the starboard apron 2, and then
tighten it to the specified torque.
3-7
Periodic checks and adjustments
Apron bolt:
8 N·m (0.8 kgf·m, 5.8 ft·lb)

Replacing the oil filter

1. Extract the engine oil with an oil changer
or drain it.
2. Remove the oil filter cover 1.
3. Place a rag under the oil filter, and then
remove the filter using a 72.5 mm (2.9 in)
oil filter wrench.
NOTE:
Be sure to clean up any oil spills.
4. Apply a thin coat of engine oil to the O-
ring of the new oil filter.
LT LT
572 572
S69J3140
69J1D11