BRKT
14. Remove the PTT oil pressure gauge
adapter set 2.
15. Install the pipe joints 3, and then tight-
ening them to the specified torque.
Pipe joint 3:
15 N·m (1.5 kgf·m, 11 ft·lb)
16. After measuring the hydraulic pressure,
connect the PTT motor leads to the bat-
tery terminals to fully extend the trim and
tilt rams.
17. Remove the reservoir cap, and then
check the fluid level in the reservoir.
18. If necessary, add fluid of the recom-
mended type to the correct level.
7-31
Bracket unit
NOTE:
If the fluid is at the correct level, the fluid
should overflow out of the filler hole when the
cap is removed.
Recommended power trim and tilt
fluid:
ATF Dexron II
19. Install the reservoir cap.
Disassembling the gear pump
1. Remove the manual valve 1 and gear
pump 2.
2. Remove the relief valve seal 3 and ball
4.
69J1D11