Installing The Propeller Shaft Housing; Installing The Water Pump And Shift Rod - Yamaha F200C Service Manual

2. Install the drive shaft housing 1, thrust
bearing 2, and original shim(s) 3 to the
drive shaft 4.
CAUTION:
Add or remove shim(s), if necessary,
when replacing the drive shaft housing or
drive shaft.
3. Install the drive shaft and drive shaft
housing to the lower case, then the pin-
ion and pinion nut, and then tighten the
nut to the specified torque.
È
NOTE:
Install the drive shaft by lifting it up slightly,
then aligning it with the pinion and the spline
of the drive shaft.
Drive shaft holder 5: YB-06201
Pinion nut:
142 N·m (14.2 kgf·m, 103 ft·lb)
4. Tighten the drive shaft housing bolts.
69J1D11
Drive shaft and lower case (regular rotation model)

Installing the propeller shaft housing

1. Install the washer 1 and propeller shaft
assembly 2 into the propeller shaft
housing assembly 3.
2. Apply grease to the new O-rings.
3. Install the propeller shaft housing assem-
bly into the lower case.
4. Install the bolts 4, ring 5, and bolts 6,
and then tighten the bolts 4 to the speci-
fied torque.
Propeller shaft housing bolt 4:
30 N·m (3.0 kgf·m, 22 ft·lb)
Installing the water pump and shift
rod
1. Install the shift rod assembly 1.
1
2
3
4
5
6
7
8
9
6-20