Checking The Gearshift Operation - Yamaha F200C Service Manual

5. Check that the alignment mark a is
between the alignment marks b. If not,
repeat steps 2–4.
6. Place the throttle cam 7 against the fully
closed stopper c, and check that there
is a minimum clearance d of approxi-
mately 1.0 mm (0.04 in).
7. Adjust the position of the throttle cable
joint until its hole is aligned with the set
pin e on the throttle cam.
69J1D11
CAUTION:
The throttle cable joint must be screwed
in a minimum of 8.0 mm (0.31 in) f.
8. Connect the cable joint, install the clip,
and then tighten the locknut.
9. Check the throttle cable for smooth oper-
ation and adjust the cable length, if nec-
essary, repeating steps 1–7.

Checking the gearshift operation

1. Check that the
smoothly when shifting from neutral into
forward or reverse. Adjust the shift cable
length if necessary.
2. Set the gearshift to the neutral position.
3. Loosen the locknut 1, remove the clip
2, and then disconnect the shift cable
joint 3.
4. Align the set pin a in the center of the
shift bracket and with the alignment
marks b on the bracket.
Control system
S69J3340
gearshift operates
3-12
1
2
3
4
5
6
7
8
9