Removing The Power Unit - Yamaha F200C Service Manual

POWR
CAUTION:
• Do not twist, turn inside out, or bend the
timing belt beyond the maximum limit of
25 mm (1.0 in) j, otherwise it may be
damaged.
• Do not get oil or grease on the timing
belt.
11. Turn the drive sprocket clockwise two
turns, and then check that all alignment
marks are aligned.
NOTE:
Do not turn the drive sprocket counterclock-
wise.
12. Install the wiring harness guide, stator
coil bracket, and blowby hose, and con-
nect the pulser coil coupler and stator
coil couplers.
13. Connect all couplers, leads, and hoses.
14. Install the Woodruff key.
15. Install the flywheel magnet.
5-23
Power unit
È
CAUTION:
Apply force in the direction of the arrows
shown, to prevent the flywheel holder
from slipping off easily.
NOTE:
Apply engine oil to the flywheel magnet nut
before installation.
Flywheel magnet holder: YB-06139
Flywheel magnet nut:
240 N·m (24 kgf·m, 174 ft·lb)
16. Install the intake silencer, ignition coil
cover, and flywheel magnet cover.

Removing the power unit

1. Remove the flywheel magnet cover and
intake silencer.
2. Remove the retaining plate 1 and hold-
ers 2, and then disconnect the throttle
cable 3 and shift cable 4.
69J1D11