Adjusting The Throttle Link And Throttle Cable Operation (Without A Stop Bolt) - Yamaha F200C Service Manual

CHK
ADJ
9. Place the throttle cam 0 against the fully
closed stopper f, and check that there
is a minimum clearance g of approxi-
mately 1.0 mm (0.04 in).
10. Adjust the position of the throttle cable
joint until its hole is aligned with the set
pin h on the throttle cam.
CAUTION:
The throttle cable joint must be screwed
in a minimum of 8.0 mm (0.31 in) i.
11. Connect the cable joint, install the clip,
and then tighten the locknut.
3-11
Periodic checks and adjustments
S69J3300
12. Check the throttle cable for smooth oper-
ation and adjust the cable length, if nec-
essary, repeating steps 1–10.
Adjusting the throttle link and
throttle cable operation (without a
stop bolt)
NOTE:
• Be sure to synchronize the throttle valves
before adjusting the throttle link.
• For synchronizing procedures, see Chapter
4, "Synchronizing the throttle valve."
1. Loosen the locknut 1, remove the clip
2, and then disconnect the throttle cable
joint 3.
2. Loosen the locknut 4 and disconnect the
link rod 5 from the magnet control lever
6.
3. Adjust the link rod 5 so that the align-
ment mark a is between the alignment
marks b. Then, push the magnet control
lever 6 in the direction of the arrow to
eliminate any looseness.
4. Install the link rod 5 and tighten the lock-
nut 4.
69J1D11