Assembling The Drive Shaft Housing - Yamaha F200C Service Manual

LOWR
CAUTION:
Add or remove shim(s), if necessary,
when replacing the forward gear or lower
case.
Forward bearing installer 3:
YB-06430
Driver handle 4: YB-06071
3. Install the needle bearing outer case into
the lower case.
È
NOTE:
Apply engine oil to the needle bearing outer
case before installation.
Needle bearing installer 5:
YB-06435
Pinion gear bushing installer 6:
YB-06029-4
Needle bearing remover and installer
7:
YB-06213
4. Install the needle bearing into the needle
bearing outer case.
6-45
Lower unit
NOTE:
Apply engine oil or grease to the needle
bearing, and then install it.
5. Install the new needle bearings into the
reverse gear to the specified depth.
È
Needle bearing installer 8:
YB-06435
Driver handle 9: YB-06071
Depth b:
20.75–21.25 mm (0.817–0.836 in)
Depth c:
4.25–4.75 mm (0.167–0.187 in)
6. Install the thrust bearing and reverse
gear into the lower case.

Assembling the drive shaft housing

1. Install the needle bearing into the drive
shaft housing to the specified depth.
Needle bearing installer and remover
1:
YB-06194
Driver handle 2: YB-06071
69J1D11