Assembling The Propeller Shaft Housing - Yamaha EK40G Service Manual

LOWR
Assembling the propeller shaft
housing
1. Apply grease to new oil seals, and then
install them into the propeller shaft hous-
ing to the specified depth.
NOTE:
Install an oil seal halfway into the propeller
shaft housing, then the other oil seal.
Driver rod L3 1: 90890-06652
Needle bearing attachment 2:
90890-06613
2. Install the new ball bearing onto the pro-
peller shaft housing using a press.
Driver rod LS 3: 90890-06606
Ball bearing attachment 4:
90890-06634
6-15
Lower unit
1
2
6F660650
3
4
6F660670
3. Install the original shim(s) 5 onto pro-
peller shaft housing 6, then install the
reverse gear assembly into the propeller
shaft housing.
6
5
cC
Add or remove the shim(s), if necessary, if
replacing the reverse gear, propeller shaft
housing, or lower case.
6F660660
6H95G11