Assembling The Propeller Shaft Assembly; Assembling The Propeller Shaft Housing - Yamaha F200C Service Manual

LOWR
Assembling the propeller shaft
assembly
1. Install the dog clutch 1 as shown.
NOTE:
Install the dog clutch 1 with the "F" mark a
facing toward the shift plunger.
Assembling the propeller shaft
housing
1. Install the needle bearing into the propel-
ler shaft housing to the specified depth.
È
NOTE:
Install the needle bearing with the manufac-
ture identification mark a facing toward the
oil seal (propeller side).
Driver handle 1: YB-06071
Drive shaft needle bearing remover
and installer 2:
YB-06196
Depth b:
25.05–25.55 mm (0.986–1.006 in)
6-13
Lower unit
2. Apply grease to the new oil seals, and
then install them into the propeller shaft
housing to the specified depth.
È
NOTE:
Install an oil seal halfway into the propeller
shaft housing, then the other oil seal.
Oil seal installer 3: YB-06195
Driver handle 4: YB-06071
Depth c:
4.75–5.25 mm (0.187–0.207 in)
3. Install the ball bearing into the propeller
shaft housing.
NOTE:
Install the ball bearing with the manufacture
identification mark facing toward the propeller
shaft housing.
Forward bearing installer 5:
YB-06430
Driver handle 6: YB-06071
69J1D11