Assembling The Propeller Shaft Housing - Yamaha 250GETO Service Manual

Assembling the propeller shaft
housing
1. Install the needle bearing into the pro-
peller shaft housing to the specified
depth.
1
3
b
NOTE:
9 Install the needle bearing with the manufac-
ture identification mark a facing toward the
oil seal (propeller side).
9 Be careful not to let the stopper c get out
of position when using the driver rod SS 1.
Driver rod SS 1: 90890-06604
Needle bearing attachment 2:
90890-06610
Bearing depth plate 3:
90890-06603
Depth b:
25.05 – 25.55 mm (0.98 – 1.00 in)
2. Apply grease to new oil seals, and then
install them into the propeller shaft hous-
ing to the specified depth.
d
NOTE:
Install an oil seal halfway into the propeller
shaft housing, then the other oil seal.
Bearing inner race attachment 4:
90890-06640
6S35H11
Propeller shaft housing (regular rotation model)
c
a
b
2
S6P26050E
4
S6P26060E
Depth d:
4.75–5.25 mm (0.187–0.207 in)
3. Install the new ball bearing into the pro-
peller shaft housing using a press.
6
5
NOTE:
Install the ball bearing with the manufacture
identification mark e facing toward the pro-
peller shaft housing (propeller side).
Ball bearing attachment 5:
90890-06656
Driver rod LS 6: 90890-06606
1
e
2
3
S6S16140
4
5
6
7
8
9
6-10