Checking The Hydraulic Pressure - Yamaha F200C Service Manual

BRKT
6. Install the wave washer A and washer
B into the yoke C.
7. Install the new O-ring and yoke C to the
motor base.
NOTE:
Place a clean cloth over the end of the arma-
ture shaft and carefully push the armature
from the yoke with a pair of pliers as shown.

Checking the hydraulic pressure

1. Check the hydraulic pressure. Check the
internal parts if out of specification.
2. Fully extend the power trim and tilt rams.
3. Loosen the pipe joints 1, and then
remove the pipe joint a.
7-29
Bracket unit
4. Install the PTT oil pressure gauge
adapter set 2.
NOTE:
Cover the removed pipe joint a with a rag.
PTT oil pressure gauge adapter set:
YB-06580
5. Connect the PTT motor leads to the bat-
tery terminals to retract the tilt ram, and
then measure the hydraulic pressure.
Ram PTT motor lead
Light green (Lg)
Down
Sky blue (Sb)
Hydraulic pressure (down):
6.7–8.7 MPa (68–89 kgf/cm
Battery
terminal
+
-
2
)
69J1D11