Depth a:
4.25–4.75 mm (0.167–0.187 in)
2. Apply grease to the new oil seals, and
then install them into the drive shaft
housing to the specified depth.
È
NOTE:
Install an oil seal halfway into the drive shaft
housing, then the other oil seal.
Oil seal installer 3: YB-06195
Driver handle 4: YB-06071
Depth b:
0.25–0.75 mm (0.01–0.03 in)
Installing the drive shaft
1. Install the forward gear to the lower case.
2. Install the drive shaft housing 1, thrust
bearing 2, and original shim(s) 3 to the
drive shaft 4.
69J1D11
Drive shaft and lower case (counter rotation model)
CAUTION:
Add or remove shim(s), if necessary,
when replacing the drive shaft housing or
drive shaft.
3. Install the drive shaft, housing, pinion,
and pinion nut, and then tighten the nut
to the specified torque.
È
NOTE:
Install the drive shaft by lifting it up slightly,
then aligning it with the pinion and the spline
of the drive shaft.
Drive shaft holder 5: YB-06201
Pinion nut:
142 N·m (14.2 kgf·m, 103 ft·lb)
4. Tighten the housing bolts.
Installing the propeller shaft housing
1. Install the propeller shaft housing assem-
bly into the lower case.
1
2
3
4
5
6
7
8
9
D
S69J6515
6-46