Assembling The Propeller Shaft Housing - Yamaha E60HWD Service Manual

LOWR
Assembling the propeller shaft
housing
1. Install the needle bearing into the pro-
peller shaft housing to the specified
depth.
1
3
2
NOTE:
Install the needle bearing with the manufac-
ture identification mark a facing toward the
oil seal (propeller side).
Driver rod SS 1: 90890-06604
Needle bearing attachment 2:
90890-06612
Bearing depth plate 3
90890-06603
Depth b:
25.0—25.5 mm (0.984—1.004 in)
2. Apply grease to new oil seals, and then
install them into the propeller shaft hous-
ing.
4
5
NOTE:
Install an oil seal halfway into the propeller
shaft housing, then the other oil seal.
Driver rod LS 4: 90890-06606
Ball bearing attachment 5:
90890-06655
6-15
Lower unit
a
b
6F660150
c
6F660160
Depth c:
4.5—5.5 mm (0.177—0.214 in)
3. Install the washer 6 and new ball bear-
ing 7 onto the reverse gear 8 using a
press.
8
9
Bearing inner race attachment 9:
90890-06662
4. Install the reverse gear assembly into the
propeller shaft housing using a press.
0
Needle bearing attachment 0:
90890-06612
6
7
6F660170
69D60080
69D5G11