Yamaha F200C Service Manual page 69

NOTE:
• To increase the idle speed, turn the throttle
stop screw in direction a.
• To decrease the idle speed, turn the throttle
stop screw in direction b.
7. Tighten the port throttle stop screw 5
until it contacts the throttle body lever 6.
8. Loosen the locknut 8, remove the clip
9, and then disconnect the throttle cable
joint 0.
9. Adjust the link rod 3 so that the align-
ment mark c is between the alignment
marks d. Then, push the magnet control
lever 4 in the direction of the arrow to
eliminate any looseness.
69J1D11
10. Install the link rod 3, and then tighten
the locknut 2.
11. Check that the alignment mark c is
between the alignment marks d. If nec-
essary, repeat steps 8–10.
12. Place the throttle cam A against the fully
closed stopper e, and check that there
is a minimum clearance f of approxi-
mately 1.0 mm (0.04 in).
13. Adjust the position of the throttle cable
joint until its hole is aligned with the set
pin g on the throttle cam.
Control system
3-14
1
2
3
4
5
6
7
8
9