Installing The Upper Case; Removing The Power Trim And Tilt Unit - Yamaha F200C Service Manual

BRKT

Installing the upper case

1. Install the upper and lower mounting
bolts into the swivel bracket 1 simulta-
neously.
2. Install the upper mounting nut 2 and
lower mounting nut 3, and then tighten
them to the specified torques.
Upper mounting nut 2:
72 N·m (7.2 kgf·m, 52 ft·lb)
Lower mounting nut 3:
72 N·m (7.2 kgf·m, 52 ft·lb)

Removing the power trim and tilt unit

1. Fully tilt the outboard motor up, and then
support it with the tilt stop lever 1.
7-17
Bracket unit
WARNING
After tilting up the outboard motor, be
sure to support it with the tilt stop lever.
Otherwise, the outboard motor could sud-
denly lower if the power trim and tilt unit
should lose fluid pressure.
NOTE:
If the power trim and tilt does not operate,
loosen the manual valve and tilt the outboard
motor up manually.
2. Remove the anode 2 and bolts 3.
3. Loosen the self-locking nut 4, and then
move the clamp brackets slightly in the
direction of the arrows.
WARNING
Do not remove the tilt stop lever 1 from
the clamp brackets.
4. Remove the plastic ties 5, and then pull
out the PTT motor lead 6.
5. Remove the circlip 7, then the shaft 8.
6. Remove the power trim and tilt unit 9.
69J1D11