Assembling The Power Trim And Tilt Motor - Yamaha F200C Service Manual

Armature coil continuity
Commutator segments b
Segment-laminations c
Segment-shaft d
5. Check the circuit breaker for continuity.
Replace the brush holder if there is no
continuity.
6. Measure the brush length. Replace if out
of specification.
Brush length limit e:
4.0 mm (0.16 in)
7. Check the base for corrosion or damage.
Replace if necessary.
69J1D11
Continuity
No continuity
No continuity
Power trim and tilt unit
8. Check the bearing for damage or wear.
Replace if necessary.
Assembling the power trim and tilt
motor
1. Install the new oil seal 1 and bearing 2
into the motor base 3 as shown.
2. Connect the PTT motor leads 4 to the
brush holder 5 and then install the brush
holder 5 to the motor base 6.
3. Install the brushes 7 and springs 8 to
the brush holder as shown.
4. Install the bearing 9 to the armature 0.
5. Push the brushes 7 into the holders,
and then install the armature 0.
1
2
3
4
5
6
7
8
9
7-28