Installing The Drive Shaft; Installing The Propeller Shaft Housing - Yamaha EK40G Service Manual

LOWR
4. Install the thrust bearing and roller bear-
ing assembly.
9
NOTE:
Apply gear oil to the inside and outside of the
thrust washer and roller bearing outer race
before installation.
Ball bearing attachment 9:
90890-06631
Driver rod LS 0:
90890-06606

Installing the drive shaft

1. Install the roller bearing, then the drive
shaft, original shim(s), pinion, and circlip.
NOTE:
Take care the rollers will not fall off.
6-19
Lower unit
0
6F660770
6F660790

Installing the propeller shaft housing

1. Install the washer 1 and propeller shaft
assembly 2 into the propeller shaft
housing assembly 3.
2. Install the forward gear assembly to the
propeller shaft housing assembly.
3. Apply grease to new O-rings.
2
4. Fit the new seal into the lower case cap.
a
a
NOTE:
Cut the seal so that it projects out a about
0.8 mm (0.03 in) from the lower case cap.
cC
Do not pull the seal.
3
1
6F660910
6F660807
6H95G11