4. Install the reverse gear assembly to the
propeller shaft housing using a press.
Bearing inner race attachment 0:
90890-06661
Installing the propeller shaft housing
1. Install the washer 1, propeller shaft
assembly 2, into the propeller shaft
housing assembly 3.
2. Apply grease to the new O-rings.
62Y5A11
Propeller shaft housing
3. Install the propeller shaft housing assem-
bly 4 into the lower case, and then
install the straight key 5, claw washer
6, and ring nut 7.
4. Tighten the nut to the specified torque.
NOTE:
Secure the ring nut by bending one tab a
into the slot in the ring nut and the other tabs
toward the propeller shaft housing assembly.
Ring nut wrench 3 8: 90890-06511
Ring nut wrench extension 9:
90890-06513
Ring nut 7:
105 N·m (10.5 kgf·m, 76 ft·lb)
1
2
3
4
5
6
7
8
9
6-16