Installing The Shift Rod And Oil Seal Housing; Installing The Propeller Shaft Housing - Yamaha E60HWD Service Manual

Drive shaft holder 3 1:
90890-06517
Pinion nut holder 2:
New: 90890-06715
Current: 90890-06505
Pinion nut:
95 N·m (9.5 kgf·m, 68 ft·lb)
Installing the shift rod and oil seal
housing
1. Install the shift rod 1, new O-ring 2 and
plate assembly 3.
8
3
2
1
4
NOTE:
Using a special service tool 4, check the for-
ward, neutral and reverse position of the shift
rod to set the neutral position.
Shift rod push arm 4:
90890-06052
69D5G11
2. Install a new O-ring 5, new gasket 6, oil
seal housing 7 and the dowels 8.

Installing the propeller shaft housing

1. Install the original shim(s) 1, and pro-
peller shaft assembly 2 into the propeller
shaft housing assembly 3.
2. Apply grease to new O-rings.
7
6
5
cC
Add or remove shim(s), if necessary, if
replacing the reverse gear, propeller shaft
housing, or lower case.
3. Install the propeller shaft housing assem-
bly 4, straight key 5 and lock washer 6
into the lower case, and then tighten the
ring nut 7 to the specified torque.
69D60220
69D60045
Drive shaft and lower case
2
3
1
69D60230
6
5
4
8
9
6F660075
1
2
3
4
5
6
7
7
8
69D60245
9
6-20