Installing The Propeller Shaft Housing - Yamaha 250GETO Service Manual

Drive shaft holder 6 7:
90890-06520
Pinion nut holder 8:
90890-06715
Pinion nut:
142 N·m (14.2 kgf·m, 104.7 ft·lb)
4. Install the drive shaft housing 9, and
then tighten the drive shaft housing bolt
0.
9
NOTE:
Apply LOCTITE 572 to the drive shaft hous-
ing bolts before installation.
Drive shaft housing bolt 0:
18 N·m (1.8 kgf·m, 13.3 ft·lb)
Installing the propeller shaft
housing
1. Set the shift rod joint and dog clutch 1 to
the neutral position as shown.
2. Apply grease to a new O-rings, and then
install it onto the propeller shaft housing.
3. Install the washer 2 and propeller shaft
assembly 3 into the propeller shaft
housing assembly.
6S35H11
Drive shaft and lower case (regular rotation model)
7
8
6F660310
0
6S360106
1
3
NOTE:
Face the shift plunger connect part to
upward.
4. Install the propeller shaft housing assem-
bly into the lower case, and then tighten
the bolts 4 to the specified torque.
5. Install the ring 5 and bolts 6.
NOTE:
Apply LOCTITE 271 to the drive shaft hous-
ing bolts 4 and LOCTITE 572 to the bolts 6
before installation.
Propeller shaft housing bolt 4 :
30 N·m (3.0 kgf·m, 22.1 ft·lb)
Bolt 6 :
18 N·m (1.8 kgf·m, 13.3 ft·lb)
2
6S360110
6
5
4
6S360120
6-18
1
2
3
4
5
6
7
8
9