FBII XL-4 Programming Manual page 81

Zone Buzzer On Trouble
168 TRB BUZ Zxxx
YES
Indicates whether the keypad buzzer (sounder) will be active upon a trouble condition. If
YES the trouble buzzer will be activated at all keypads within the partition where this zone
has been defined.
In order to silence the trouble buzzer it is necessary to enter a valid user code or perform the
RESET ( ) command (based on the question 050). Press the 0 key to toggle through the
available choices.
U L
In UL Listed systems, fire zones must be programmed as YES.
Zone Chime Enable
169 EN CHME Zxxx
NO
Specifies whether this zone should activate the chime feature. If the chime mode is enabled
then this particular zone will activate the chime audible signal at the keypad every time the
zone is faulted. This will occur only when the system is disarmed. Press the 0 key to toggle
through the available choices.
Zone 750ms Response (HW Zones Only)
170 EN 750M Zxxx
YES
Indicates whether this zone has 750-millisecond response. If not enabled, the normal zone
response is approximately 250 milliseconds.
This question only relates to hardwired zones (either the first 8 zones on the control panel or the
eight additional zones available through the 7105 zone expander module.
Press the 0 key to toggle through the available choices.
Zone Pulse Count Time
171 PUL CT Zxxx
__ (MINUTES)
The zone pulse count feature can be configured to require that this individual zone undergo a
certain number of activations (debounces) within a defined time period before an alarm
condition is tripped. Enter the time in minutes. A value of 15 indicates that the feature is
disabled for this zone. Default value = 15.
U L
For UL Listed systems this must be programmed as "15".
Section 8 - LCD Keypad Programming Questions
8–59