FBII XL-4 Programming Manual page 41

The clock must be set prior to entering an auto-arming schedule. If the clock is not already set,
refer to the Quick Commands section of the Installation and Setup Guide.
3. Press 2. The keypad will display:
Su Autoarm HR
12:00 a Part 1
The Part number will be the partition number the keypad is enabled in.
4. Set the hour by entering a number from 1 to 12 for the desired hour (HR).
5. Press the Instant key. The HR portion of the display will change to MIN.
6. Set the minute by entering a number from 0 to 59 for the desired minute (MIN).
7. Press the Code key to change from AM (a) to PM (p). NOTE: The CODE key must be
pressed at least once before you can exit this mode.
8. Press the Stay key to advance to the desired day of the week. Note that if the # key is
pressed while in the auto arm mode, the display will show --:-- meaning that the time is
disabled and there will be no auto arm for that day.
9. Re-enter the programming mode to continue programming.
Clock Set Reporting Path
035 CLOCK PATH
NONE
Specifies the transmission path for the Schedule Change reporting code to the CS. A clock set
signal can be transmitted to the Central station every time the time on the clock is changed
at the keypad. The options are:
CS#1 ONLY
CS#2 ONLY
CS#1 & CS#2
CS#1 BU CS#2
CS#2 BU CS#1
NONE
Press the 0 key to toggle through the available choices.
This reporting path will cover all partitions in a multi-system installation based on the exception
reporting option specified in question 035. The code transmitted for clock set is defined in
question 089.
Test Signal Reporting Path
036 TEST CS PATH
NONE
Specifies to which Central Station the periodic system test signals is transmitted. The
options are:
CS#1 ONLY
CS#2 ONLY
Section 8 - LCD Keypad Programming Questions
Primary rec. only
Secondary rec. only
Both receivers always
CS#1 backed up by CS#2
CS#2 backed up by CS#1
No transmission
Primary rec. only
Secondary rec. only
8–19