FBII XL-4 Programming Manual page 44

XL-4, XL-4B, and XL-5 LCD Keypad Programming Manual
Bypass Transmission Type
043 XMIT BYPASS
ON BYPASS
Specifies when bypasses are transmitted to the Central Station. The options are:
ON BYPASS
ON ARMING
Bypassing can be enabled or disabled by zone.
U L
This must be programmed "ON BYPASS" for UL Listed systems.
Press the 0 key to toggle between the available choices.
Auto Unbypass Enable
044 AUTO UNBY EN
YES
Indicates whether bypassed zones will automatically be unbypassed upon system disarm.
Bypasses will be generated for the bypassed zones if a bypass code has been defined. This
option will only unbypass zones if there are no other alarm or trouble conditions present.
U L
This must be programmed "YES" in UL Listed systems.
Press the 0 key to toggle between the available choices.
Arming Output Level
045 ARM OUT LEV
HIGH
Indicates the desired voltage level on trigger output for arming status. The system contains
one voltage output located on the trigger connector of the control panel that represents the
current arming state for the entire panel. If the system contains multiple partitions then this
output will be at the selected level if any of the partitions are armed. The options are HIGH
and LOW. Press the 0 key to toggle between the available choices.
Bell Test At Arming
046 BELL TST ARM
NO
Indicates whether a bell test will be performed when the system is armed. Default = NO.
The bell output is assumed to be relay 1, and will only operate with relay 1.
U L
This must be programmed as "YES" in UL Listed Commercial Burglary applications.
Press the 0 key to toggle between the available choices.
8–22
Transmit at time of bypass
Transmit upon system arming
Version 4