FBII XL-4 Programming Manual page 26

XL-4, XL-4B, and XL-5 LCD Keypad Programming Manual
40P 1400 PART EX
40P 2300 PART EX
Use the 0 key to toggle through the available choices.
The following receivers/formats are compatible for UL listed systems:
FBI Model CP220: All formats except 4x2 Express
ADEMCO Model 685: All formats except FBI Superfast
Silent Knight Model 9000: 10PPS, Standard no Parity
This question will be skipped if signals are not transmitted to CS#1 (Question 003).
CS Format Examples
The control panel can transmit a variety of formats to the Central Station. Listed below is an
explanation of each format and the overall format of the digits transmitted. Further
information concerning the definition of the codes can be located in the appropriate questions
within this manual. Consult your Central Station manager to determine the formats
acceptable to your Central Station.
Point ID (PID) Format
This is a DTMF format that transmits the following information:
ACCT 18 QXYZ GG CCC
Where:
ACCT = Four Digit Account Number
18 = Identifies PID format
Q = Event Type
XYZ = Event Code. Dedicated event types exist to designate the type of event. These codes
will generate English language printouts on both the FBI CP220 and ADEMCO 685
receivers. The valid event codes are described in Table 1 - PID Event Codes and Table 3 -
Zone PID Event codes.
GG = Group or Partition initiating the signal
CCC = Zone or user number (in Decimal), depending on the signal type
This format requires a High/Low handshake frequency from the CS receiver.
FBI Superfast
DTMF Format transmitting the following information:
ACCT AZZ S
Where:
ACCT = Four Digit Account Number
8–4
40 Pulses Per Second, 1400 Hz handshake, Partial Extended
40 Pulses Per Second, 2300 Hz handshake, Partial Extended
1 = New Event or Opening
3 = Restore or Closing
6 = Previously reported event
Version 4