FBII XL-4 Programming Manual page 24

XL-4, XL-4B, and XL-5 LCD Keypad Programming Manual
Telephone Number Entry
All phone number should be entered with any area codes or access characters needed to dial
the telephone number from the control panel location. The valid digits for all phone numbers
are 0- 9,B, C, or D. The phone digits are entered as follows:
0-9 Actual telephone number digits
B (Shift 2)
C (Shift 3)
D (Shift 4) #
The SHIFT key is the
Do not enter blanks or separators between the digits as this will be interpreted as the end of
the telephone number. A totally blank phone number indicates that the phone number does
not exist. For example, a blank CS#2 Phone number indicates that the panel does not
communicate with the secondary Central Station.
To blank out an existing telephone number move the cursor to the first position and depress
the SHIFT key ( ) followed by the 8 key. To advance the next programming question press
the NEXT QUESTION (or STAY) key. Telephone numbers within the control panel can
contain up to 32 digits. Since the LCD display contains only sixteen characters a secondary
display will automatically appear if a phone number greater than 16 characters is entered.
This secondary display will be denoted with a small left arrow in the last position of the first
line.
Dump Telephone Number
002 DUMP PH. #
_
The control panel stores the last 128 events that have occurred. This system log information
can be viewed by an Installer through a LCD keypad, remotely read by the EZ-MATE PC
Software, or dumped automatically to a remote serial printer. The remote printer can be
located at the Alarm Company, Central Station or other remote location The DUMP
telephone number defines the telephone number of this remote printer and modem and can
vary from account to account.
In addition the system log can be output to a local serial printer. In order to utilize the local
serial printer leave the DUMP phone number blank (enter
The local printer function requires use of the Serial Printer Interface module (model 7130).
If the panel should not transmit system log information then leave this question blank. The
DUMP telephone number can contain up to 32 digits. Additional information for the Auto
Dump function is defined in questions 184-194. The Auto Dump feature requires a modem or
module 7130 and serial printer capable of 300-baud operation.
8–2
3 Second delay
(asterisk) shift key on the keypad as shown on the programming overlay.
8 to clear a phone number).
Version 4