FBII XL-4 Programming Manual page 43

Test Time - Minute
039 TEST TIME MN
00 (00 - 59)
Enter the minute within the hour, for transmission of a system test signal.
Download Reporting Path
040 DOWN PATH
NONE
Specifies the Central Station transmission path for a signal confirming a system download.
This signal will be sent upon any valid remote communications connection with the control
panel. This allows the Central Station to be notified upon a remote communications session
(upload/download or remote commands). The options are:
CS#1 ONLY
CS#2 ONLY
CS#1 & CS#2
CS#1 BU CS#2
CS#2 BU CS#1
NONE
Press the 0 key to toggle through the available choices.
Bypass Reporting Path
041 BYPASS PATH
NONE
Specifies the Central Station transmission path for system bypasses. The options are:
CS#1 ONLY
CS#2 ONLY
CS#1 & CS#2
CS#1 BU CS#2
CS#2 BU CS#1
NONE
Press the 0 key to toggle through the available choices.
Disable Bypass On Stay
042 DIS BYP STAY
NO
Indicates whether a bypass signal transmission will be disabled when performing STAY
arming. If answered as NO then bypasses will be transmitted to the Central Station. If YES
then bypasses will not be transmitted.
In either case, the bypasses will be reflected in the system log. Press the 0 key to toggle
between the available choices.
This question also determines whether bypasses will be transmitted when performing group
bypasses. If answered as NO then individual bypasses will be transmitted to the Central
Station. If YES, then bypasses will not be transmitted when a group bypass is performed.
Section 8 - LCD Keypad Programming Questions
Primary rec. only
Secondary rec. only
Both receivers always
CS#1 backed up by CS#2
CS#2 backed up by CS#1
No Download transmissions
Primary rec. only
Secondary rec. only
Both receivers always
CS#1 backed up by CS#2
CS#2 backed up by CS#1
No Bypass transmissions
8–21