FBII XL-4 Programming Manual page 40

XL-4, XL-4B, and XL-5 LCD Keypad Programming Manual
If any of the expander modules are defined within this question then the module must be
connected to the control panel.
External Relay Modules
032 XTRIG MODE
NO
This question selects if a XL-4705 relay module is connected to the control panel. Press the 0
key to toggle between the available choices.
Open/Close CS Reporting Path
033 OP/CL PATH
NONE
Specifies the transmission path for opening and closing signals. If the system includes
exception reporting then opening and closings mean that the events occurred within the
schedule time for that day. The options are:
CS#1 ONLY
CS#2 ONLY
CS#1 & CS#2
CS#1 BU CS#2
CS#2 BU CS#1
NONE
Press the 0 key to toggle through the available choices.
The opening and closing reporting path will cover all partitions in a multi-system installation.
U L
Openings and closings shall be enabled in UL Listed Commercial Burglary applications.
Partition Auto Arming By Day
034 ENAB AUTOARM
NNNNNNNN
This question indicates whether Auto Arming by partition by day should be enabled. To
enable this function for a partition, advance to the partition desired and depress the 0 key
(toggle) to change the N (no) to Y (yes). When this function is enabled, an auto-arming
schedule must be entered into the system. To enter an auto arming schedule proceed as
follows:
1. Exit the programming mode.
2. Enter #3 from the keypad. The keypad will display:
System clock
(1) Clock (2) Arm
8–18
Primary rec. only
Secondary rec. only
Both receivers always
CS#1 backed up by CS#2
CS#2 backed up by CS#1
No O/C transmissions
Version 4