FBII XL-4 Programming Manual page 37

The definition of the actual user codes is not performed within the Installer Keypad Programming
sequence. Definition or modification of user codes can be performed through keypad entry by the
end user or installer or remotely by an authorized operator through the EZ- Mate PC software.
Select User Number
025 SEL USER #
000 000=SKIP
This question indicates the desired user number to be modified. Entry of 000 will skip to the
next group of questions (System Attributes). The XL-4 and XL-4B can contain up to 64
different users while the XL-5 can contain up to 128 different users. The user numbers range
from 001 to 065 for the XL-4 and XL-4B. The user numbers range from 001 to 128 for the XL-
5.
User Authorization Level
026 US LEV #XXX
_ (1-7)
Authorization levels within the control panel determine the functions that each user may
perform within the control panel. The values range from 1 (highest) to 7 (lowest) as defined
below:
LEVEL 1
LEVEL 2
LEVEL 3
LEVEL 4
LEVEL 5
LEVEL 6
LEVEL 7
Consult the Installation and Setup Guide or User Guide for further information on the
functions performed by various users. NOTE: Users with authorization levels of 1,2 or 3 are
considered Master Users.
User CS Open/Close ID
027 O/C ID #xxx
___ 001- 255
This indicates the digits to be transmitted to the Central Station when this user opens or
closes the premise. The default value for each user CS code will be the user number. If
Open/Close signals are not transmitted or if the reporting format does not transmit O/C by
user ID (example STANDARD) then this value will be ignored.
The user code transmitted to the Central Station may be restricted by the type of
transmission format selected. For example, if you are transmitting in either the standard,
extended or 4x2 formats there is only one digit to transmit a user code, therefore you can
only identify user codes in the 0 - 15 range. The Point ID (PID) format will allow you to
transmit any desired user code from 001 - 255.
SUPER USER
Arm, Disarm, Bypass, Program Users, Change Partition Assignments in ALL
partitions
Arm, Disarm, Bypass, Program Users, and Change Partition Assignments in
own partitions
Arm, Disarm, Bypass, and Program Users
Arm, Disarm, and Bypass
Arm and Disarm
DURESS CODE
Arm ONLY Code (Maid Code)
Section 8 - LCD Keypad Programming Questions
8–15