Rod
CONTROL VALVE
REMOVAL AND INSTALLATION
Pre-removal Operation
Cleaning of Pipings with Steam
l
Power Steering Fluid Draining
l
(Refer to GROUP 37A - On-vehicle Service.)
Rear Suspension Assembly Removal
l
(Refer to GROUP 34- Rear Suspension Assembly.)
15 Nm
11 ft.lbs.
15 Nm
11 ft.lbs.
25 ft.lbs.
Removal steps
Pressure hose
1.
2. Pressure tube
3. O-ring
Pressure
Power
i p
Temporarily attach the tie rod end assembly to the cylinder
assembly at the place of dimension as illustrated.
NOTE
To adjust the assembly dimensions of the tie rod end assembly,
remove the dust cover clip and rotate the rod.
12 Nm
9 ft.lbs.
35 Nm
25 lt.lbs.
tube (RR)
tube (RL)
TSB Revision
Post-installation Operation
Rear Suspension Assembly Installation
l
(Refer to GROUP 34 - Rear Suspension Assembly.)
Power Steering System Refilling and Bleeding
l
(Refer to GROUP 37A - On-vehicle Service.)
4WS System Bleeding (Refer to P.378-4.)
l
4WS System Operation Checking
l
(Refer to i?37B-5.)
24 Nm
35 Nm
25 ft.lbs.
7. O-ring
pipe
12. Control valve
12 Nm