Mitsubishi 3000GT Service Manual page 1020

42-14
Window glass-end
I
Stabilizer
Stabilizer
inner rear
inner front
Door wind& regulator
BODY
9. Force the stabilizer inner front onto the glass guide slider
of the window glass assembly and tighten in position.
Stabilizer
inner front
10. Force the up stop onto the glass stop of the window
glass assembly and tighten in position.
Caution
Do not turn the adjusting bolts of guide tracks.
up stop
12. Adjust the delta sash. so that the window glass end and
the delta sash lip end are positioned as illustrated and
tighten in position.
in.)
13. Install the drip line weatherstrip.
14. Install the front pillar trim.
15. Install the door trim and the waterproof film. (Refer to
16. Open and close the door and move up and down the
window glass to check fitting of the door.
(When not removing and installing the door
window glass)
1. Remove the door trim and waterproof film. (Refer to
2. Loosen the bolts and nuts of the following parts.
l
l
l
l
l
. up stop
3. Lift the window glass up to its highest position.
TSB Revision
Glass guide front track
Glass guide rear track
Door window regulator
Stabilizer inner front
Stabilizer inner rear