Panasonic S-ICX Technical Manual page 144

Chapter 5. Key Telephone Features
To erase a code stored on an FF key:
Note: You cannot use the following procedure to clear FF keys that have been assigned as CO/
Exchange lines. CO/Exchange line keys can only be cleared through system programming.
1. Lift the handset or press the ON/OFF key.
2. Press the PROG key.
3. Press the FF key that was programmed.
4. Press the HOLD key.
To check a programmed FF key (Display Phone Only):
1. Lift the handset or press the ON/OFF key.
2. Press the CONF key.
3. Press the FF key to be checked.
4. Replace the handset or press the ON/OFF key.
Considerations
• If a new code is programmed into a key, the previously programmed code is erased.
• FF keys assigned as CO/Exchange lines must be cleared using system programming before new
FF assignments can be made.
• The System can be programmed so that MCO 1 Exchange Line Access calls automatically use
Automatic Route Selection (ARS).
• The ANSWER key functions as listed in the table below.
Status
Idle
Off-Hook
Note: When the extension has 1 non-appearing CO/Exchange line on hold and 1 non-appearing CO/
Exchange line at talk, ANSWER key operation is ignored and you can't put the 2nd non-appearing
CO/Exchange line on hold.
5-46
Action
Action
Condition
No incoming ring
Incoming ring
Off-hook signaling
No off-hook signaling
ICX (International) issued December 1999
Intercom dial tone
Programmed code displays
Cleared Function displays
Intercom dial tone
C displays
Programmed data displays
Operation when ANSWER key is pressed
Ignore.
Monitor ON (speaker) - Auto Answer for incom-
ing ring.
Answer for off-hook signaling. Current conver-
sation will be put on hold automatically.
Ignore.
Section 700 - Operation
Result
Result
ICX-40-700