Mco Trunk (Exchange Line) Access - Panasonic S-ICX Technical Manual

Chapter 5. Key Telephone Features
Operation
To place a call using MCO Line Preference:
1. Lift the handset.
2. Dial the phone number.
Considerations
• You can press the ON/OFF key to get intercom dial tone.

MCO Trunk (Exchange Line) Access

The System supports up to 5 MCO groups for each MCO tenant group. You can seize an idle
exchange line from the MCO exchange line group by entering the MCO access code.
Operation
To seize an idle exchange line:
1. Lift the handset or press the ON/OFF key.
2. Enter the exchange line access number (9(UK/HK) or 0 or
81-84). (See Table 5-7.)
3. Dial the phone number.
Considerations
• The System supports up to 576 outside lines in a six-cabinet configuration. These lines can be
divided into 99 different exchange line groups.
• Each exchange line group can support up to 50 outside lines.
• Each MCO Tenant Group can have up to 5 MCO exchange line access codes. System defaults
for MCO exchange line access codes are displayed in the following table.
• MCO1 can have up to 5 exchange line groups assigned by the Advanced Exchange Line Group
feature.
• MCO1 access code is used for Automatic Route Selection (ARS) access code.
Table 5-7. MCO Trunk (Exchange Line) Access Codes
MCO Group
MCO1
MCO2
5-86
Action
Action
Exchange Line Access
Code
9
(UK/HK) or 0
81
ICX (International) issued December 1999
Section 700 - Operation
Result
• Outside dial tone
• CO XXX displays (where XXX =
exchange line number)
Dialed phone number displays
Result
Intercom dial tone
• Outside dial tone
• CO XXX displays (where XXX =
exchange line number)
Dialed phone number displays
ICX-40-700