Set Absence Messages - Panasonic S-ICX Technical Manual

Section 700 - Operation
FF3
FF4
FF5
FF6
FF7
FF8
FF9
FF10
Note: Once in a data entry level, you must either enter an acceptable value or restore the previous
value before proceeding. For instance, if you change an entry to an unacceptable value and then press
FF1 to move to the PSD Assignment menu, you will not be able to proceed. You must first enter an
acceptable value.
Operation
To enter User Maintenance mode:
1. At a telephone with a COS that allows user login, press the
ON/OFF key.
2. Press the PROG key.
3. Press the * key twice (* *).
4. Press the CONF key.
Note: Your extension's Class of Service must be properly set to allow User Maintenance access.
Also, only one user may enter User Maintenance or System Programming at a time.

Set Absence Messages

Description
This menu item specifies absence messages.
Operation
To set Absence Messages using either a large-display or small-display phone:
1. If not already in User Maintenance mode, enter User Main-
tenance mode. (See "To enter User Maintenance mode:" on
page 4-3.)
2. At the 81 level, enter 12.
3. Press the HOLD key.
4. Press the HOLD key.
ICX-40-700
Moves to Extension Name menu
Moves to Verified ID Code menu
Moves to Call Forward ID Code menu
Moves to Message Key ID Code menu
Moves to System Mode menu
Moves to Walking /Station Lock TRS
Moves to TRF of CWRD
Moves to CID Logging Ext.
Action
Action
ICX (International) issued December 1999
Chapter 4. User Maintenance
Result
81-
User MAINT displays
Result
81-
User MAINT displays
8112-
Absence Message displays
Enter Msg # displays
4-3