Xerox Phaser 6121MFP Service Manual page 158

Error Messages and Codes
3-52
Message
Memory full
at SMTP Server
(Press any key)
USB memory full
Scan to USB memory
(Press any key)
Unable to resolve IP
for xxxx Server
(Press any key)
Communication error
with xxxx Server
(Press any key)
Connection failed
with host
(Press any key)
Disconnected from
xxxx Server
(Press any key)
Disconnected from
USB memory
(Press any key)
No suitable paper
Load ( ) paper
Remove original in
document feeder
No suitable paper
Check duplex setting
Reload 12 original
into Document Feeder
and press OK key
Recipient memory is
full, cannot accept
fax or Email
Manual input is
limited to 16 fax
recipients
Duplicate setting
TCP/IP is disabled
No Email Server
FTP is disabled
SMB is disabled
SMTP is disabled
Fax Comm Error
Description
The SMTP server's memory is full.
The USB memory is full.
The specified IP address for the server cannot be
resolved. Where xxxx can be SMTP, POP3, LDAP, or
FTP.
A communication error occurred with the specified
server. Where xxxx can be SMTP, FTP, SMB, or USB.
The connection with the host failed.
The printer lost connection with the server. Where
xxxx can be SMTP, POP3, DNS, FTP, SMB, or LDAP.
The printer lost connection with the USB memory.
The paper type required for the job needs to be
loaded.
This error occurs when there is an original in the ADF,
but the job calls for flatbed scanning.
An error occurred that requires the originals to be
reloaded.
The recipient machine memory is full and cannot
currently accept fax or email.
Group dial can be set to 50 destinations by CWIS, but
at the Control Panel a maximum of 15 address can be
specified.
This error occurs when a duplicate Scan or Fax
Address entry is made.
The functionality is disabled.
This error occurs when the email server doesn't
respond. Verify that the SMTP settings are correct.
The functionality is disabled.
The functionality is disabled.
The functionality is disabled.
A communication error occurred during the fax job.
Phaser 6121MFP Service Manual