Xerox Phaser 6121MFP Service Manual page 139

Phaser 6121MFP Service Manual
Error code: 0091
Definition: Sending out DCS+TCF signal 3 times consecutively but no signal in
response from receiver.
Solution:
1. Check the phone line for noise, and if necessary, replace the telephone line or
contact your Telecom Service Provider.
2. Boost the TX Level of sender's machine.<*1>
3. Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 0093
Definition: Received DCN signal after sending out DCS signal for V.34.
Solution:
1. Resend the fax.
2. Register the telephone number in the printer.
3. Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 0094
Definition: Time out during transmit ECM frame or RCP command.
Solution:
1. Change the machine setting to ECM OFF, then resend again.
2. Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 009A
Definition: Can't detect any signal after sending CI signal.
Solution:
1. Check the phone line for noise, and if necessary, replace the telephone line or
contact your Telecom Service Provider.
2. Boost the TX Level of sender's machine.
3. Print out the protocol report, and provide it to Technical Support for analysis.
Error Messages and Codes
3-33