Xerox Phaser 6121MFP Service Manual page 116

Error Messages and Codes
3-10
Code Description
0022 Owing to noise interference on the line, receiving side can not receive
correct data within specified time (no ECM).
0023 Received PWD error in RSD or upgrade F/W.
0024 TX and RX machine have different machine IDs in upgrade F/W.
0025 TX and RX machine have different company IDs in upgrade F/W.
0026 Remote monitor level error, remote side can not access in upgrade F/W.
0027 Remote monitoring prohibited.
002A Line problem.
0030 Cannot receive any signal within 6 seconds at phase D.
0031 Received incorrect signal at phase D (not EOP, MPS, EOM, DCS PPS_Q,
PPS_Q, etc.).
0032 Carrier signal not received within 6 seconds after sending MCF or RTP,
RTN signal.
0033 Received DCN signal at phase D within pages (not last page).
0039 In non-ECM mode, data received but the next line data not received
within 13.1 seconds.
003F Remote side TSI not defined in machine one touch or speed dial
directory.
0040 Carrier signal not received within 6 seconds after sending CTR.
0041 Carrier signal not received within 6 seconds after sending PPR.
0042 Correct signal not received after sending RNR signal.
0043 Received incorrect signal at phase D in ECM mode.
0044 Carrier /FSK signal not received within 6 seconds after sending MCF in
ECM mode.
0045 Correct signals not received after sending RNR response with ERR signal.
0046 Received incorrect signal after sending RNR (Receiver Not Ready).
0047 Correct signal not received after sending ERR signal.
0048 Correct signal not received after receiving PPS_PRI_Q, PRI_Q, or
EOR_PRI_Q.
0049 Correct signal not received within 13 seconds after sending PIP/PIN
signal.
004A Line energy over threshold last 60 seconds after MCF, and can not detect
FSK or carrier signal in ECM mode.
004B Cannot detect correct FSK signal even though detected FSK tone within 6
seconds.
004C Handshake failure during re-train or between page in V.34 RX.
004E Received DCN signal after sending DIS in V.34.
004F Remote side disconnected after sending ANSam in V.8 phase.
0050 Correct signal not received after sending CJ signal in V.8 phase.
0051 Phase 3 signal not received within 20 seconds after phase 2 in V.34.
Phaser 6121MFP Service Manual