Xerox Phaser 6121MFP Service Manual page 136

Error Messages and Codes
Transmission Error Troubleshooting
3-30
Code Possible Causes of Error
00FD Cannot speed down to lower speed in ECM mode.
00FE Memory full for transmission.
00FF Redial failed.
<*1> in the following tables indicate that the adjustment is in the Service Mode.
For instructions on entering Service Mode, see page 6-2.
Error code: 0080
Definition: Can't detect any G3 signal within 35 sec. specified by ITU-T in
phase B.
Solution:
1. Check the phone line for noise, and if necessary, replace the telephone line or
contact your Telecom Service Provider.
2. Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 0081
Definition: Received DTC signal in transmission phase.
Solution:
Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 0082
Definition: Transmitting unit receives a signal other than DIS or DTC. And DCN in
phase B.
Solution:
Print out the protocol report, and provide it to Technical Support for analysis.
Error code: 0083
Definition: Detected FSK signal, but can't receive any signal within 35 seconds.
Solution:
1. Check the phone line for noise, and if necessary, replace the telephone line or
contact your Telecom Service Provider.
2. Boost the TX Level of sender's machine.
3. Print out the protocol report, and provide it to Technical Support for analysis.
Phaser 6121MFP Service Manual