Thermosensor - KYMCO People Service Manual

12. COOLING SYSTEM

THERMOSENSOR

THERMOSENSOR REMOVAL
Remove the met-in box and carrier.
Remove the body cover, center cover and
rear fender cover A.
Drain the coolant.
Disconnect the thermosensor wire.
Remove the thermosensor.
THERMOSENSOR INSPECTION
Suspend the thermosensor in a pan of
water over a burner and measure the
resistance through the sensor as the water
heats up.
Temperature( )
50
Resistance(:)
154
THERMOSENSOR INSTALLATION
Apply 3-BOND No. 1212 sealant or
equivalent to the thermosensor threads and
install it into the thermostat housing.
Connect the thermosensor wire.
Fill the radiator with coolant. ( Ö 3-9)
Install the center cover, met-in box and seat.
( Ö 2-3)
Be sure to bleed air from the cooling
system.
80 100 120
52 27 16
PEOPLE/PEOPLE S 250
Thermosensor
Thermosensor Wire
Thermosensor
Thermometer
Thermosensor Wire
Thermosensor
12-14