KYMCO People Service Manual page 225

18. STARTING SYSTEM
STARTER MOTOR
REMOVAL
x Before removing the starter motor, turn
the ignition switch OFF and remove the
battery ground. Then, turn on the
ignition switch and push the starter
button to see if the starter motor
operates properly.
Remove the seat, met-in box and carrier.
( Ö 2-6)
Remove the body cover, center cover and
rear fender A together. ( Ö 2-6)
Remove the nut goes to the starter relay and
relax cable band to disconnect the starter
motor cable.
Remove the two starter motor mounting bolts
and the motor.
DISASSEMBLY
Remove the two starter motor case screws,
front cover, rear cover, motor case and other
parts.
INSPECTION
Inspect the removed parts for wear, damage
or discoloration. Replace if necessary.
Clean the commutator if there is metal
powder between the segments.
18-3
PEOPLE/PEOPLE S 250
Nut
Starter Motor Cable
Bolts
Motor Case
Front Cover
Commutator
Band
Rear Cover
Case Screws