Engine Removal - KYMCO People Service Manual

5. ENGINE REMOVAL/INSTALLATION

ENGINE REMOVAL

Drain the coolant. ( Ö3-9)
Remove the met-in box, carrier. ( Ö2-6 )
Remove the frame body cover, center cover
and rear fender A together. ( Ö2-6 )
Remove the exhaust muffler. ( Ö2-10 )
Disconnect all of the A.C. generator.
Remove the nut to disconnect the starter
motor wire that goes to the starter relay.
Disconnect the secondary air vacuum tube
and fuel pump vacuum tube from inlet pipe.
Disconnect the air inlet hose (v-belt chamber)
from frame.
Loosen the intake manifold band (air cleaner
tube and inlet pipe).
Disconnect the radiator air ventilated tube
and thermosensor wire coupler from
thermostat.
PEOPLE/PEOPLE S 250
A.C. Generator Wire Connectors
Nut
Starter Relay
Secondary Air
Inlet Pipe
Vacuum Tube
Fuel Pump Vacuum Tube
Intake Manifold
Band
Thermostat
Thermosensor Wire Coupler
Starter Motor Wire
Air Inlet Hose
(V-belt Chamber)
Radiator Air
Ventilated Tube
5-2